![]() ![]() Take the transmitter back into the range of the receiver. Pull out the E-Stop pushbutton and press the Start/Horn pushbutton. Red E- Stop LED on decoder board is illuminated. Joystick, paddle lever or switch not in center position when transmitter turned on.Į-Stop failure in receiver. Transmitter is transmitting (Power LED flashing), but crane will not respond. Replace key switch, wiring or contact element. Replace battery with a fully charged battery.Ĭheck wiring on key switch. The transmitter is turned on, but does not transmit (Power LED not flashing) ![]() The Display also indicates normal transmitter communication, interference, and E-Stop conditions. Ensure that the system is securely grounded to the negative battery terminal. Replace with fully charged battery if necessary.Ĭheck the diagnostic Display on the side of the receiver to be sure power is applied. Restart system by pressing Start twice.Ĭheck battery to ensure a full charge. If the system is being initialized from an E-Stop condition, the Start button must be pressed twice - first to clear the E-Stop, then again, to start the system.īe sure that all joysticks and paddle levers are in center position when the Start button is activated. Joystick or paddle lever not in center position. System will not initialize after normal start-up procedure. Consult BMS-2 Operator Manual for details. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |